Skip to content

Battery and Power

Cyber Fidget looks after its rechargeable battery whether you are using the device or letting it rest.


How long does a charge last?

These ballparks use a 400 mAh battery capacity and current measured on a bench device. Typical use varies with volume, brightness, and how full the battery is:

What you are doing Roughly how long
Playing games, watching screensavers, browsing menus 5 to 6 hours
Hosting the web portal (WiFi on, phone connected) about 2.5 hours
Asleep in your pocket or a drawer one to two months

Two useful facts behind the table: the device draws about the same current whatever foreground app is running (the screen and processor dominate), and turning WiFi on roughly doubles the draw. Deep sleep uses about 1/270th of the active draw, which is why standby is measured in months, not hours.

These are runtime estimates based on current draw, rather than timed full-battery discharge tests.


Going to sleep

After about a minute without interaction (pressing a button or moving the slider), when running on battery, Cyber Fidget shows "Going to sleep now..." and enters deep sleep. Press the bottom-right button to wake it. The press that wakes it only wakes it: it doesn't also count as a press in the menu or an app.

Most apps wake to the menu. Two apps made for longer use reopen where you left them if the Fidget went to sleep by itself while they were open:

App After waking
Counter Reopens with your counts.
Home Remote Reopens and reconnects to your home WiFi.

Press Back to get to the menu as usual; the menu opens in the folder the app was started from. Every other start lands on the menu: switching the Fidget off with Power Manager, a restart, a low battery, or running different firmware than before the sleep. The hourly battery check does not change where a later button wake lands.

Reopening after sleep needs firmware 1.7.0 or later

Earlier firmware always wakes to the menu. See Updating to get the latest firmware.

While it sleeps, the device briefly wakes itself about once an hour to check the battery level, then goes right back to sleep. This takes only a fraction of a second. The screen stays dark and the lights stay off, so you will not notice the check.


When the battery runs very low

If an hourly check finds that the battery is very low, Cyber Fidget shuts down completely instead of returning to normal sleep. No button will wake it in this state. The device stops waking up so it can preserve the last bit of charge.

If the battery runs very low while you are using the device, Cyber Fidget waits until it has stayed low for a few seconds. Brief dips during loud sounds or bright lights do not trigger the shutdown. The screen then shows:

Battery empty
Recharge me!

After a moment, the device shuts down in the same protective state.

This protection matters because draining a rechargeable pouch battery too far permanently damages it. The shutdown stops the drain before the battery reaches that zone.


How to start again

Connect USB power to charge the battery. Then slide the power switch off and back on. Cyber Fidget will start normally.

Cycling the power switch always ends the protective shutdown, but charge the battery first. If the battery is still very low, the protection will simply engage again.


Storing your Cyber Fidget

For long-term storage, follow the battery manufacturer's guidance:

  • Store it with a decent charge - around half to three-quarters full is ideal. Never store it empty, and there is no need to store it at 100%.
  • Switch the device off. The power switch fully disconnects the battery.
  • Switched off, top up the charge roughly every 6 months.

Left switched on, Cyber Fidget still uses a little power while it sleeps: a full battery lasts about one to two months asleep (see the table above). If you keep it switched on but don't use it, charge it about once a month.

How it works

This protection is called under-voltage lockout (UVLO). The device reads the cell voltage from the onboard fuel gauge. The thresholds are about 3.5 V for the asleep check and about 3.3 V while running.