Skip to content

Self Test

After this page you can check your Cyber Fidget's controls, screen, lights and sound with Tools > Self Test.

Run the checks

Open Tools > Self Test on your Fidget. Keep the speaker uncovered. The sound check plays a tone at a fixed volume and uses the microphone to check that it can hear it.

The checks run in this order:

Check What happens or what to do
Charger Reads the powered fuel gauge, the chip that measures battery voltage. This checks that it answers, rather than testing a complete charging cycle.
Battery Reports No battery check yet. This step is skipped; it does not certify battery health.
Speaker and microphone Measures silence and a speaker tone. Keep the speaker uncovered.
Ready wait Shows Press any button to start with no time limit. Press a physical button when you are ready for the hands-on checks.
Buttons Press each requested button. The starting press is consumed; follow the prompts for fresh presses.
Slider Move to each end and hold there for a second.
Accelerometer Start face up, turn face down, then face up. Tilt in all directions. The accelerometer is the sensor that measures motion and tilt.
Screen Check Full white, Checkerboard and All off patterns.
LEDs Check the color cycle on all four lights, including the back light, while the small red light under the front grill blinks. Then check that all lights are off, with no faint glow.

For the screen and light checks, read the instruction screen, wait for the pattern, then press and release Enter (bottom right) for "looks right" or Back (bottom left) for a problem. Watch a full light cycle before approving it. An unanswered pattern fails after 30 seconds.

After the ready press, the app waits for all buttons to be released for 150 milliseconds before beginning the button check. If a button stays down, the check begins after 15 seconds anyway; the stuck button fails through the button check's timeout. A short Back press tests that button. Holding Back for three seconds aborts the test.

Keep the result

When it finishes, the screen shows Self Test: PASS, FAIL or ABORTED and names any check that failed. Press Back to return to the menu.

The last completed or aborted result is kept on the Fidget, including each step's result. It stays available during another run. Read it with health report; see Self Test serial commands.

The ready wait has no test timeout. A test opened from the device menu follows normal idle-sleep rules while waiting. A test started with health start over the cable stays awake while waiting. A serial command cannot replace the physical starting press.

Firmware 1.7.1 provides the checks, saved result and serial controls. The automatic checks followed by the untimed ready wait, the stuck-button release rule and the ready serial state apply to firmware 1.7.2 and later.